A process for calibrating a sensor for measuring an angle of inclination of a motor vehicle wheel, comprising a transducer which converts a unit of measurement of an angular displacement into a different quantity, constituted in the example by an electrical signal, which represents an indication of the measured angle, comprising: reading a plurality of known measurements relating to known and different angular displacements x.sub.j ; reading and storing a plurality of ordered pairs (x.sub.j, f.sub.j), where x.sub.j =known measurement of angular displacement and f.sub.j =corresponding measurement of a transduced quantity obtained from a reading; calculation of a plurality of low-degree interpolating polynomials which are lower than the plurality of ordered pairs (x.sub.j, f.sub.j), each of which results from a determined number of the ordered pairs of contiguous ordered pairs (x.sub.j, f.sub.j). A calculation of a measurement of an angular displacement not coinciding with any of known measurements for angular displacements x.sub.j is performed with at least one polynomial interpolation using at least one of the interpolating polynomials, which is selected so that a measurement f read at the sensor for measurement x of the angular displacement (to be measured) is comprised within a field described by measurements f.sub.j belonging to contiguous ordered pairs (x.sub.j, f.sub.j).

Процесс для калибрировать датчик для измерять угол наклонения колеса моторного транспорта, состоя из датчика который преобразовывает блок измерения углового смещения в по-разному количество, образовал в примере электрическим сигналом, который представляет индикацию измеренного угла, состоять из: читать множественность знанных измерений relating to знанные и по-разному угловые смещения x.sub.j; читающ и множественность приказанных пар (x.sub.j, f.sub.j), где x.sub.j = знанное измерение углового смещения и f.sub.j = соответствуя измерение а transduced количество полученное от чтения; вычисление множественности многочленн низк-gradusa интерполируя более низки чем множественность приказанных пар (x.sub.j, f.sub.j), каждое из которых приводит к от determined количества приказанных пар сопредельных приказанных пар (x.sub.j, f.sub.j). Вычисление измерения углового смещения не совпадая с любым из знанных измерений для угловых смещений x.sub.j выполнено с по крайней мере одной многочленной интерполяцией использующ по крайней мере одно из интерполируя многочленн, которое выбрана так, что измерение ф прочитанное на датчике на измерение x углового смещения (быть измеренным) будет состояться из внутри поле описанное измерениями f.sub.j принадлежа к сопредельным приказанным парам (x.sub.j, f.sub.j).

 
Web www.patentalert.com

< Two piece alignment head

< Impact tool battery pack with acoustically-triggered timed impact shutoff

> Control button

> Glint-resistant position determination system

~ 00096