A moisture resistant wall vent for use in an exterior wall of a building
includes a louvered front panel substantially in the plane of the wall
surface whether the wall has a stucco finish, conventional wall finish or
a brick surface. Alternatively, the louvered panel may be recessed from
the front edge of the vent coincident with the finish of the exterior
wall. Top, bottom, left and right side panels of the vent include
laterally extending right angle flanges disposed proximate the rear edges
to resist seepage of water along the vent into the wall. To mount the vent
in a concrete block wall, a laterally extending T-shaped lintel is
attached through slots (for the concrete block wall) disposed in the top
panel and a laterally extending plate (if used) is attached through slots
disposed in the bottom panel. The slots permit outward and inward
repositioning of the vent to accommodate the finish on the concrete block
wall and to maintain the front panel essentially in the plane of the
exterior surface of the wall. To mount the vent in a brick wall, the right
angle flanges are attached to underlying framing and an L-shaped lintel
supports the course of bricks overlying the vent. To mount the vent in an
insulating concrete form exterior wall, the right angle flanges are
attached to a buck lodged in the wall.
Сброс стены влаги упорный для пользы в exterior стене здания вклюает louvered лицевую панель существенн в плоскости поверхности стены имеет ли стена отделку stucco, обычную отделку стены или поверхность кирпича. Друг, louvered панель может быть утоплена от переднего края сброса сопадающего с отделкой exterior стены. Верхняя часть, дно, left and right бортовые панели сброса вклюает боково удлиняя фланцы прямого угла размещала proximate задние края для того чтобы сопротивлять утечке воды вдоль сброса в стену. Для того чтобы установить сброс в конкретной стене блока, боково удлиняя Т-sformirovannoe lintel прикреплено через шлицы (для конкретной стены блока) размещанные в верхней панели и боково удлиняя плита (если использовано), то прикреплена через шлицы размещанные в нижней панели. Шлицы позволяют наружу и перемещать inward сброса для того чтобы приспособить отделку на конкретной стене блока и поддержать лицевую панель необходимо в плоскости exterior поверхности стены. Для того чтобы установить сброс в стене кирпича, фланцы прямого угла прикреплены к основной обрамлять и l-shaped lintel поддерживает курс кирпичей overlying сброс. Для того чтобы установить сброс в изолируя стене конкретной формы exterior, фланцы прямого угла прикреплены к самецу оленя lodged в стене.